在核心交换机上配置DHCP做静态绑定严格限制地址分配 | 您所在的位置:网站首页 › 华为交换机静态mac地址绑定失败 › 在核心交换机上配置DHCP做静态绑定严格限制地址分配 |
拓扑图 S5700作为核心设备,配置DHCP,为办公网络分配IP地址 S2700作为接入设备 S5700配置 vlan 100 description bangong interface GigabitEthernet0/0/1 port link-type trunk port trunk allow-pass vlan 100 interface Vlanif100 ip address 192.168.10.254 255.255.255.0 S2700配置 vlan 100 description bangong interface Ethernet0/0/1 port link-type trunk port trunk allow-pass vlan 100 interface Ethernet0/0/2 port link-type access port default vlan 100 interface Ethernet0/0/3 port link-type access port default vlan 100 interface Ethernet0/0/4 port link-type access port default vlan 100 开启DHCP dhcp enable 配置地址池,并做静态绑定,PC1只能获取到192.168.10.1 PC2只能获取到192.168.10.2 剩余地址保留,不做分配,防止外部人员接入。 ip pool bangong gateway-list 192.168.10.254 network 192.168.10.0 mask 255.255.255.0 static-bind ip-address 192.168.10.1 mac-address 5489-98e7-7f28 static-bind ip-address 192.168.10.2 mac-address 5489-98d8-4d8c excluded-ip-address 192.168.10.3 192.168.10.253 dns-list 8.8.8.8 在虚接口下启用全局dhcp interface Vlanif100 ip address 192.168.10.254 255.255.255.0 dhcp select global 在PC上验证分配的地址 PC1 PC2 我们断开PC2网线,假设PC2没有接入,验证PC3是否能获取DHCP分配给PC2的地址 |
CopyRight 2018-2019 实验室设备网 版权所有 |